Answers are grounded in this paper and cite their sources.
The scanning tunneling microscope (STM) can be used to generate very fine beams of very low energy electrons (below 100 eV). Under optimum conditions the beam diameter is proportional to beam voltage and hence, when using such a beam as an exposure tool it is desirable to employ the thinnest possible resists. The metal halides in general have several properties that make them attractive candidates for use in a scanning tunneling microscope. They are easily evaporated as thin films of thickness from 10 to 100 nm. It is important that an insulating resist film be thin so that the electrons can penetrate it and the tip does not crash into it. Thicker films require a higher accelerating voltage and this degrades resolution. The sensitivity of the metal halides is on the order of 1 C/cm2, which coincides with the dose range most readily obtainable in our instrument. Finally, the exposure voltage threshold of the metal halides is thought to be in the range of a few tens of volts. This is low enough to take advantage of the very fine low energy beams available from the STM, but high enough to exclude secondary electrons from contributing to the exposure process. The calcium fluoride was thermally evaporated onto a silicon substrate. When exposed to a beam of electrons, the fluorine dissociates and the calcium converts to calcium oxide, which can be dissolved in water. We have demonstrated the ability of the STM to expose lines in CaF2 with linewidths from tens to hundreds of nanometers and have shown the degradation of resolution as beam voltage increases.
No takes yet. Share an insight, caveat, or question.
McCord et al. (1987) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: