Answers are grounded in this paper and cite their sources.
CuIn 1−x Al x Se 2 thin films are investigated for their application as the absorber layer material for high efficiency solar cells. Single-phase CuIn1−xAlxSe2 films were deposited by four source elemental evaporation with a composition range of 0⩽x⩽0.6. All these films demonstrate a normalized subband gap transmission >85% with 2 μm film thickness. Band gaps obtained from spectroscopic ellipsometry show an increase with the Al content in the CuIn1−xAlxSe2 film with a bowing parameter of 0.62. The structural properties investigated using x-ray diffraction measurements show a decrease in lattice spacing as the Al content increases. Devices with efficiencies greater than 10% are fabricated on CuIn1−xAlxSe2 material over a wide range of Al composition. The best device demonstrated 11% efficiency, and the open circuit voltage increases to 0.73 V.
No takes yet. Share an insight, caveat, or question.
Paulson et al. (2002) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: