This is the authors' abstract. We don't add key points for this paper.
Bulk-like molybdenum disulfide (MoS2) thin films were deposited on the surface of p-type Si substrates using dc magnetron sputtering technique and MoS2/Si p-n junctions were formed. The vibrating modes of E12g and A1g were observed from the Raman spectrum of the MoS2 films. The current density versus voltage (J-V) characteristics of the junction were investigated. A typical J-V rectifying effect with a turn-on voltage of 0.2 V was shown. In different voltage range, the electrical transporting of the junction was dominated by diffusion current and recombination current, respectively. Under the light illumination of 15 mW cm−2, the p-n junction exhibited obvious photovoltaic characteristics with a short-circuit current density of 3.2 mA cm−2 and open-circuit voltage of 0.14 V. The fill factor and energy conversion efficiency were 42.4% and 1.3%, respectively. According to the determination of the Fermi-energy level (∼4.65 eV) and energy-band gap (∼1.45 eV) of the MoS2 films by capacitance-voltage curve and ultraviolet-visible transmission spectra, the mechanisms of the electrical and photovoltaic characteristics were discussed in terms of the energy-band structure of the MoS2/Si p-n junctions. The results hold the promise for the integration of MoS2 thin films with commercially available Si-based electronics in high-efficient photovoltaic devices.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Hao et al. (2015) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: