Key result
Aortic transverse residual strains show compressive inner and tensile outer layers with significant regional differences.
Why the study?
Residual strains in the transverse section of the aorta and their distribution were not directly measured and characterized.
Direct measurement of residual strains in the porcine aorta reveals a distribution that reduces stress concentration under physiological load, with significant regional variations.
Answers are grounded in this paper and cite their sources.
Porcine aortic residual strains require zero-stress accounting in models; extends biomechanical research but leaves open human translation.
Residual strains were measured in the porcine aorta. Segments were cut from the aorta perpendicular to its longitudinal axis. Microdots of water-insoluble black ink were sprinkled onto the transverse sectional surface of the segments in the no-load state. The segments were then cut radially, and sectional zero-stress states were approached. The coordinates of selected microdots (2-20 microns) were digitized from photographs taken in the no-load state and the zero-stress state. Residual strains in the transverse section were calculated from the displacement of the microdots. The circumferential residual strains on the inner wall and outer wall were calculated from the circumferential lengths in the no-load state and the zero-stress state. Results show that the circumferential residual strain is negative (compressive) in the inner layer of the aortic wall and positive (tensile) in the outer layer, whereas the radial residual strain is tensile in the inner layer and compressive in the outer layer. This residual strain distribution reduces the stress concentration in the aorta under physiological load. The experimental results compared well with theoretical estimations of a cylindrical model. Regional difference of the residual strain exists and is significant (P < 0.01), e.g., the circumferential residual strains on the inner wall of the ascending, descending thoracic, and abdominal regions of the aorta are -0.133 +/- 0.019, -0.074 +/- 0.020, and -0.046 +/- 0.017 (mean +/- SD), respectively. More radial cuts of a segment produced no significant additional strains. This means that an aortic segment after one radial cut can be considered as the zero-stress state.
No takes yet. Share an insight, caveat, or question.
Han et al. (1996) studied this question. Measurement of transverse residual strains was evaluated on Circumferential residual strains (p=<0.01). Measurement of transverse residual strains in porcine aorta revealed compressive strains in the inner layer and tensile strains in the outer layer, with significant regional differences.
Synapse has enriched 10 related papers. Consider them for comparative context: