Answers are grounded in this paper and cite their sources.
High modulus steel (HMS), an Fe-based TiB 2 -reinforced composite, is promising for lightweight structural applications because of its high stiffness and wear resistance. However, conventional casting often causes TiB 2 coarsening and inhomogeneous distribution. This study investigated the fundamental melting and solidification behavior of nominal 15 vol% TiB 2 -reinforced Fe–17Cr alloy using single-bead electron-beam remelting of dense cast disks under PBF-EB-relevant thermal conditions, rather than full powder-bed PBF-EB fabrication. The alloy was irradiated without powder deposition at beam powers of 600–1800 W and preheating temperatures up to 1000 °C. Increasing beam power and preheating temperature promoted apparent TiB 2 dissolution/refinement, elemental homogenization, and local microstructural modification. The remelted regions contained Fe–Cr–Ti–B-rich complex boride-like candidate phases, spinodal-decomposition-like nanoscale modulation in α -Fe, and Al 2 O 3 –TiB 2 τ -particles that assisted α -Fe grain refinement through heterogeneous nucleation and pinning. High-temperature preheating suppressed major cracking, while local Vickers hardness increased in the remelted regions owing to combined grain-refinement, dispersion-strengthening, dislocation-strengthening, and nanoscale-modulation effects. These results provide mechanistic guidance for future PBF-EB processing of TiB 2 -reinforced HMS, while the findings should be interpreted as dense-substrate single-bead remelting behavior, not direct evidence for fully built PBF-EB components. This clarification helps define the next experimental steps for translating these mechanisms to powder-bed processing.
No takes yet. Share an insight, caveat, or question.
Matsuo et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: