Answers are grounded in this paper and cite their sources.
This study investigates the asymmetric oil discharge behavior and thermal performance of tapered roller bearings with under-race lubrication using Computational Fluid Dynamics (CFD) simulations and oil discharge experiments. A dimensionless large-end oil discharge ratio is introduced to quantify lubricant partition between the two bearing ends. The predicted discharge behavior is validated experimentally over 2000-6000 rpm, with a maximum relative deviation below 4%. Results show that centrifugal effects promote lubricant migration toward the large end, leading to dominant large-end discharge under most conditions. Increasing oil flow rate weakens preferential large-end discharge and improves cooling, although the additional thermal benefit becomes limited when the flow rate increases from approximately 105 to 140 L/h. Increasing rotational speed reduces lubricant retention and intensifies thermal accumulation; at 105 L/h, the area-averaged oil volume fraction on the roller and cage surfaces decreases by approximately 83% from 2000 to 6000 rpm. Shifting the oil inlet holes toward the small end and increasing the inlet hole diameter suppress preferential large-end discharge and improve thermal behavior, whereas increasing the number of inlet holes provides limited benefit. A 4 mm shift toward the small end reduces the large-end oil discharge ratio by approximately 13% at 3000 rpm. These results indicate that optimizing inlet-hole axial position and diameter is more effective than simply increasing inlet-hole number or oil-supply rate, providing practical guidance for under-race lubrication design and thermal management of tapered roller bearings.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: