Answers are grounded in this paper and cite their sources.
Hydrodynamic dispersion of analyte bands is a critical transport phenomenon in microfluidic systems, where it can either deteriorate separation resolution or enhance mixing, mass transfer, and targeted delivery. Y-shaped microchannels offer a versatile geometry for dispersion control because they enable the merging of two independent streams, the formation of a stable internal interface, and the simultaneous modulation of hydrodynamic, electrokinetic, and diffusive interactions. This numerical study investigates the electroosmotic dispersion of neutral analyte bands in two Y-shaped microchannel configurations containing an internal Navier-slip interface. In the band–band mode, two analyte bands are simultaneously injected through the upper and lower inlet branches and migrate adjacent to each other along the main channel. In the band–fluid mode, only the upper branch contains an analyte band, while the lower branch carries an analyte-free fluid stream. The coupled electric-field and flow problems were solved in COMSOL Multiphysics using the finite element method. The steady electric potential and velocity fields were obtained from the Laplace, continuity, and momentum equations, and the transient cross-sectionally averaged concentration was predicted using a one-dimensional advection–diffusion model. In the band–band mode, the effects of the inlet-branch angle θ B , effective wall zeta-potential parameter ζ , and Navier slip length prescribed at the internal interface β were examined. In the band–fluid mode, the effects of the lower-to-upper inlet flow-rate ratio V 0 r , interfacial Navier slip length β , and lower-to-upper dynamic-viscosity ratio η μ 0 were analyzed. Increasing the flow-rate ratio from V 0 r = 0.75 to V 0 r = 4 reduced the dispersion of the upper-branch analyte by approximately 10% and 30%, respectively, in the presence of Navier slip compared with the no-slip case. Minimum dispersion was achieved at θ B = 75 ° , ζ = − 1 V , and β = 5 mm for the band–band mode, and at V 0 r = 0.75 , β = 5 μm , and η μ 0 = 1 for the band–fluid mode. These results highlight interfacial slip, inlet geometry, and flow-property contrast as effective parameters for engineering analyte-band dispersion in electroosmotic Y-shaped microfluidic platforms.
No takes yet. Share an insight, caveat, or question.
Aslani et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: