Answers are grounded in this paper and cite their sources.
Additively manufactured aerospace fuel nozzles possess complex internal channels and superior structural integration; however, their practical application is restricted by poor surface quality caused by powder adhesion and the balling effect during additive manufacturing. Ultrasonic-assisted abrasive flow machining (UAAFM) provides a promising solution for improving the surface integrity of such complex components, while the influence mechanism of ultrasonic parameters on abrasive flow behavior and material removal remains insufficiently understood.In this study, a coupled acoustic–flow–particle numerical model was developed to investigate the effect of ultrasonic vibration frequency on the machining characteristics of additively manufactured fuel nozzles. The transient interaction among ultrasonic excitation, abrasive flow behavior, and particle transport was analyzed based on a turbulence model, non-Newtonian abrasive medium model, and Lagrangian particle tracking method. The effects of ultrasonic frequencies ranging from 25 to 80 kHz on velocity distribution, dynamic pressure, wall stress, and abrasive particle motion were systematically investigated. Furthermore, experimental investigations under ultrasonic frequencies of 0–80 kHz were performed using laser confocal microscopy and scanning electron microscopy to validate the simulation results.The results demonstrate that ultrasonic vibration significantly enhances abrasive particle activity and improves the micro-cutting capability during abrasive flow machining. An optimal machining condition was achieved at 25 kHz, where enhanced flow disturbance, acoustic cavitation-assisted effects, and abrasive impact behavior reached a favorable balance. Under this condition, the surface roughness was reduced to 0.268 μm, representing approximately 90% improvement compared with conventional abrasive flow machining without ultrasonic assistance. Excessively high ultrasonic frequencies weakened the effective energy transfer due to increased attenuation, resulting in reduced material removal capability.This work provides new insights into the frequency-dependent material removal mechanism in ultrasonic-assisted abrasive flow machining and offers an effective strategy for precision finishing of additively manufactured aerospace components with complex internal structures.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: