Answers are grounded in this paper and cite their sources.
Parking garage lighting needs an uninterrupted power supply, but solar PV output varies with irradiance and weather. This study implements a solar PV–PLN system with an Automatic Transfer Switch (ATS) for lighting on the seventh floor of the Universitas Pamulang Viktor parking building, and examines how far the field test records support conclusions about battery backup and energy contribution. The system consists of three 550 Wp PV panels, a 60 A MPPT controller, a 48 V 50 Ah battery, an inverter with a 1,500 W continuous rating, and a 63 A two-pole ATS, serving 75 LED lamps of 18 W each (1,350 W). Observations ran for seven days, 09:00–21:00 WIB, with readings every 30 minutes on the PV, battery, and PLN sides. The load was activated in three scenarios (12, 40, and 75 lamps) without controlled repetition. The system was assembled and supplied the lighting load. The design requirement of four hours at full load is 5.4 kWh, while the battery’s usable AC energy is only about 1.82 kWh (80% DoD, 95% inverter efficiency), equivalent to roughly 81 minutes. Transfer to PLN was observed at around 18:30, when battery voltage approached 45 V. Daily PV output was recorded at 275–446 W. On the first day, battery current differed substantially between instruments (11.86 A and 22.12 A), and ATS transfer time and actual irradiance were not recorded. The 50 Ah battery is adequate only for short-term backup. The 45.83% reduction in PLN energy use is a scenario-based estimate. Battery capacity should be matched to the required backup duration, and further work needs controlled loads, calibrated instruments, and per-source energy logging.
No takes yet. Share an insight, caveat, or question.
Kurnia et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: