Answers are grounded in this paper and cite their sources.
In new energy vehicles, the adhesive layers in power battery packs must simultaneously provide strong bonding, mechanical robustness, and efficient heat conduction—properties that are notoriously difficult to integrate into a single material. In this work, a rigid‐flexible interpenetrating network (IPN) was constructed by blending silane‐terminated polyether (STPE) with epoxy (EP) at optimized mass ratios. The optimal SEA 1.6 formulation (mass ratio of STPE to EP = 1.6) exhibited a tensile strength of 13.22 MPa, an elongation at break of 660.73%, and a lap‐shear strength of 9.05 MPa, demonstrating a well‐balanced combination of mechanical robustness, ductility, and strong adhesion. Binary‐sized Al 2 O 3 fillers (45 and 5 μm) were further incorporated at an optimal coarse‐to‐fine mass ratio of 4:1 to construct densely packed thermal conduction pathways. At a total filler loading of 50 wt.%, the Al 2 O 3 /SEA 1.6 thermally conductive structural adhesive delivered a thermal conductivity of 0.79 W·m −1 ·K −1 , while retaining a lap‐shear strength of 9.47 MPa, an elongation at break of 228.77%, volume resistivity of 2.92 × 10 13 Ω·cm and breakdown strength of 19.16 kV/mm. Further increasing the loading to 70 wt.% boosted the thermal conductivity to 1.07 W·m −1 ·K −1 , a 494% enhancement over neat SEA 1.6 (0.18 W·m −1 ·K −1 ). By virtue of their moderate thermal conductivity, high bond strength, and good mechanical compliance, the fabricated thermally conductive structural adhesives emerge as attractive candidates for new energy vehicle and electronic applications.
No takes yet. Share an insight, caveat, or question.
Zheng et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: