Answers are grounded in this paper and cite their sources.
The fixed-length steel cable commonly fitted to boom sprayers gives rise to abrupt-stop oscillation under emergency braking and loses its restraining capability under strong excitation once the steel cable goes slack. In this study, a soft-stop, semi-active control method is proposed for spray-boom arm vibration. The fixed steel cable is replaced by a variable-tension steel cable whose tension is modulated by a Magnetic powder brake. A unidirectional damping force is applied in the direction opposing the vibration velocity during the downward half-cycle, and the first-mode equivalent damping ratio is thereby driven towards critical. A first-mode state-space model of the steel cable-constrained boom arm and a first-order-plus-dead-time model of the brake were established; the control force required for near-critical damping was derived and used to calibrate the quantisation factors, output scaling factors, and saturation limits of a fuzzy PID controller so that the controller output matched the actuator capacity. A DSP-based prototype was validated on a six-degree-of-freedom platform driven by field-measured excitation spectra. The performance indices reported in this paper are obtained under step excitations of 100 mm and 150 mm; the field-measured spectra are used to reproduce the chassis-motion environment of the platform and are not counted as a separate validation case. Relative to the fixed-steel cable baseline, the downward and upward peak amplitudes were reduced by 58.3% and 49.3% under the 100 mm step excitation and by 88.1% and 35.8% under the 150 mm step excitation. The settling time within ±50 mm was decreased from 3.7 s to 0.4 s under the 100 mm excitation (a reduction of 89.2%) and from 3.0 s to 0.9 s under the 150 mm excitation (a reduction of 70.0%), and the number of oscillations fell from four to one in both cases. The residual settling time itself rises from 0.4 s to 0.9 s as the excitation amplitude increases from 100 mm to 150 mm. At 150 mm, the fixed steel cable improved the downward amplitude by only 3.0%, indicating a marked degradation of its restraint as the excitation amplitude increases. The peak amplitudes obtained from simulation and from the bench tests differed by 3.4% and 2.1%.
No takes yet. Share an insight, caveat, or question.
Yan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: