Answers are grounded in this paper and cite their sources.
Ion‐implantation effects in ceramics and composites are surface‐localized to a few microns. Therefore, measurements of the mechanical properties, such as fracture toughness, of ion‐implanted ceramics and composites necessitate the use of microscopic specimens. While techniques such as microcantilever beam bending and micropillar splitting are often used to test microscopic specimens, critically comparing the results from these two techniques is important. Here, the micropillar splitting technique was used to measure the fracture toughness of monolithic SiC (1.94 ± 0.27 MPa·m 1/2 ) and carbon nanotubes (CNTs)‐reinforced SiC nanocomposites before and after C 2+ ion implantation. These results are compared with fracture toughness values previously measured for the same materials using the microcantilever beam bending technique. There is good agreement between the fracture toughness of monolithic SiC measured by micropillar splitting and microcantilever beam bending (~1.94 vs. ~2.42 MPa·m 1/2 , respectively, for the nonirradiated condition), as well as with literature values. However, the fracture toughness of the nanocomposites measured by the micropillar‐splitting technique was consistently lower than that obtained by microcantilever beam bending, both under nonirradiated conditions (~0.99 vs. ~2.70 MPa·m 1/2 , respectively) and after irradiation (~1.55 vs. ~4.76 MPa·m 1/2 , respectively). This difference was attributed to the pronounced microstructural inhomogeneity resulting from CNT addition and ion implantation.
No takes yet. Share an insight, caveat, or question.
Steinbach et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: