Answers are grounded in this paper and cite their sources.
Water leakage threatens underground infrastructure, yet conventional oil‐based polyurethane grouts face a trade‐off between slurry fluidity and cured‐material strength and water resistance. Graphene oxide (GO) and nano‐SiO 2 were surface‐modified with 3‐aminopropyltriethoxysilane (APTES, commercially designated KH‐550), washed, vacuum‐dried, and dispersed into the polyol component before reaction with polymethylene polyphenyl isocyanate (PAPI). The total modified filler loading was fixed at 4 g while the GO/nano‐SiO 2 ratio was varied. The 2 g/2 g formulation increased compressive strength by 64.8% to 4.22 MPa and retained 4.09 MPa after 7‐day immersion. The 1 g/3 g formulation provided the highest tensile strength and lowest water uptake among the tested compositions, with higher Component A apparent viscosity as a trade‐off. A two‐dimensional plane‐strain finite element model evaluated the mechanical response of a cured plug prepared from the 2 g/2 g formulation under hydraulic loading. Compression dominated the calculated body‐failure tendency; longer plugs reduced failure risk, whereas wider fractures reduced pressure‐bearing capacity. These findings support application‐specific formulation screening and comparative assessment of plug geometry. Direct injectability, permeability, and field performance require further validation.
No takes yet. Share an insight, caveat, or question.
Cao et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: