Answers are grounded in this paper and cite their sources.
Self‐forming screw joining of fiber‐reinforced polymer (FRP) laminates presents unique process challenges arising from coupled thread formation, torque partitioning, and laminate damage mechanisms that distinguish these joints from conventional metallic assemblies. This study systematically investigates clampload generation and relaxation behavior in FRP screw joints, evaluating four screw configurations: metric, self‐tapping, self‐cutting, and self‐drilling across bidirectional woven and chopped strand mat glass FRP laminates under controlled installation conditions. Torque–angle and clampload responses are characterized to quantify torque‐to‐clampload conversion efficiency and identify the process‐level mechanisms governing joint performance. Results reveal that clampload develops only after full thread seating, with a linear torque–clampload relationship in the tightening regime. Metric screws achieve the highest conversion efficiency, while self‐forming screws exhibit reduced efficiency due to energy dissipation during thread formation and installation‐induced microstructural damage both inherent to the self‐forming process in FRP laminates. Laminate architecture exerts a dominant influence: bidirectional laminates provide superior radial fiber confinement and higher clampload, whereas chopped strand mat laminates exhibit reduced efficiency driven by higher transverse compliance. Thermal aging studies quantify progressive torque relaxation across all screw‐laminate combinations through residual torque measurements, revealing architecture and screw‐type‐dependent relaxation rates. An experimentally calibrated predictive model is developed and validated, incorporating seating torque and an effective torque coefficient to relate installation torque to generated clampload. The model demonstrates good agreement with experimental results across all configurations, providing a practically applicable and physically grounded framework for the design and optimisation of self‐forming screw joints in FRP composite structures.
No takes yet. Share an insight, caveat, or question.
Ravichandran et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: