Answers are grounded in this paper and cite their sources.
Flat-tubular segment-in-series solid oxide fuel cells (FT-SIS-SOFCs) offer a promising route for high-voltage SOFC systems; however, current leakage through conductive cermet supports remains a critical challenge, and the design principles for porous insulating layers that simultaneously provide electrical decoupling and sufficient gas transport have not been fully established. Herein, porous insulating layers were introduced between the support and the anode of an FT-SIS-SOFC to suppress current leakage through the cermet support and preserve gas transport. SrZrO3 (SZO) is a promising insulating material as it shows a stable perovskite structure at high temperatures and under a reducing atmosphere, and its resistivity is sufficiently high. Single cells with SZO insulating layer thicknesses from 0 µm to 108 µm were fabricated, and their performance exhibited a nonmonotonic thickness dependence. Thin SZO layers resulted in residual coupling between the anode and support, which introduced additional polarization. By contrast, excessively thick layers increased gas-transport resistance. The maximum A-C power density was achieved at an SZO thickness of approximately 73 µm, while a thickness range of 73-80 µm was identified as the practical optimal window for balancing electrical decoupling and gas transport. Using this optimized design, a 14-cell FT-SIS-SOFC was fabricated, with 12 cells effectively connected in series for power generation. The device delivered an open-circuit voltage of 12 V at 700 °C and a peak power density of 150 mW cm-2 at 800 °C. These results demonstrate the feasibility of porous SZO as an insulating layer for high-voltage FT-SIS-SOFCs.
No takes yet. Share an insight, caveat, or question.
Chen et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: