Answers are grounded in this paper and cite their sources.
This study proposes the application of tangential hydrogen injection as an alternative swirl-generation concept for centrifugal nuclear thermal rocket (CNTR) fuel elements and numerically evaluates its gas-side thermal-hydraulic performance. Two swirl-generation mechanisms are investigated: tangential inlet-induced (TII) swirl, produced by tangential hydrogen injection, and wall rotation-induced (WRI) swirl, produced by mechanically rotating boundaries. A two-dimensional axisymmetric-swirl unsteady Reynolds-averaged Navier–Stokes (URANS) framework with Reynolds Stress Model (RSM) turbulence closure was validated against experimental swirling-flow data and subsequently applied to compare the two configurations under matched swirl intensity, inlet mass flow rate, geometry, and thermal boundary conditions. The results show fundamentally different radial swirl distributions: TII produces a Rankine-vortex-type flow with swirl concentrated toward the core and decaying downstream, whereas WRI maintains a forced-vortex-type flow with strong near-wall tangential motion. At the baseline condition of 200 RPM-equivalent swirl and a wall heat flux of 3000 W/m 2 , TII increases the global Nusselt number from 10.63 to 12.66, corresponding to an approximately 19% enhancement over WRI, while producing nearly identical pressure loss. Increasing the imposed swirl from 100 to 600 RPM-equivalent increases the global Nusselt number of TII from 11.50 to 16.48, whereas that of WRI remains nearly unchanged. The resulting Figure of Merit (FoM) for TII increases from approximately 1.06 to 1.63. The radial pressure differences generated by TII and WRI are comparable near the injection region, indicating that both mechanisms generate centrifugal fields that may contribute to fuel retention; however, the TII-induced field decays downstream while the WRI field is continuously sustained by wall rotation. Overall, the results demonstrate the potential of TII for enhancing gas-side heat transfer while generating a centrifugal field and potentially reducing reliance on mechanically rotating components in CNTR fuel elements. Further, two-phase simulations, injector-geometry and outlet-orifice optimization, and system-level analyses are required to determine its feasibility under representative CNTR operating conditions.
No takes yet. Share an insight, caveat, or question.
Sachdeva et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: