Answers are grounded in this paper and cite their sources.
This study presents a process-constrained design, analytical modeling and Silicon-on-Insulator (SOI) multi-project wafer (MPW) fabrication of a Vibrating Ring Gyroscope (VRG). The SoI design rules mandated peripheral anchors and prohibited central supports. A dual-concentric ring architecture interconnected through semicircular flexures was developed to preserve modal symmetry. To maintain fabrication compliance, the radius and width of semicircular flexures were optimised to match the constraints of SOI process. The curved geometry allows vibrations in drive and sense modes. The novelty in design is the inclined plates of drive and sense masses to achieve higher overlap. Finite element analysis predicts near-mode-matched drive and sense frequencies of 110.95 kHz and 110.98 kHz (∆ f = 30 Hz). Electrostatic and squeeze-film damping modeling predict drive amplitude of 1.95 µm, scale factor of 7.95 nm at 1 rad/sec input rate, scale factor of 2.88 aF/(deg/s), quality factor of 2140 and ARW of 0.0432 o /√(hr). Fabrication using a three-mask SOI process with deep reactive ion etching (DRIE) demonstrated dimensional deviation below 2\%.
No takes yet. Share an insight, caveat, or question.
Venkataram et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: