Answers are grounded in this paper and cite their sources.
Abstract― Porous silicon with high porosity and layer thickness is of interest as a material for sensor systems due to its high reactivity. Control of these parameters over a wide range can be achieved by using the Pt-assisted etching method. The conductivity type and resistivity of the original single-crystal silicon substrate have a significant impact on the parameters and properties of the resulting porous silicon, since they determine the amount and distribution density of the deposited metal (platinum) on the surface, as well as the etching rate of the silicon. This paper shows the influence of the conductivity type and specific resistivity of a silicon single-crystal substrate on the morphology of a porous layer formed by Pt-assisted etching. Platinum particles are deposited on silicon substrates by chemical deposition from an aqueous solution containing HF and H2PtCl6. The dynamics of formation of a porous silicon layer was studied using scanning electron microscopy and gravimetric method. The dependences of porosity, thickness of the porous layer and the etching rate of silicon on the duration of the process, conductivity type and specific resistance of the substrate were established. The results show that a high value of the porosity to thickness ratio is characteristic of porous layers formed on KEM-0.001 and KDB-0.01 silicon substrates, while a low value is characteristic of porous layers formed on KEF-4.5 substrates. The obtained data can contribute to the improvement of technologies related to the use of porous silicon.
No takes yet. Share an insight, caveat, or question.
Olga V. Volovlikova (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: