Answers are grounded in this paper and cite their sources.
Inconel 718 is widely used for high-temperature load-bearing components, but localised wear and thermal fatigue cracking can render an entire part unserviceable. This study repairs such damage by depositing compositionally matched GA718 powder and regulating the linear energy density. Gas-atomised GA718 powder was clad onto Inconel 718 sheets via multi-pass double-layer laser cladding (18 tracks, 2 layers). The resulting layers were continuous, crack-free and metallurgically bonded to the substrate, with a γ + γ′-Ni3(Al, Ti) constitution matching that of the substrate. Laser power, scanning speed, powder feed rate and overlap rate were varied to span η = P/V = 150–250 J/mm. As η increased, the solidification structure changed from planar crystals at the interface to cellular and columnar dendrites. Rapid solidification refined the grains and raised the hardness of all claddings above 230 HV5. At 800 °C a compacted oxide glaze reduced the wear rate to 0.43 × 10−4 mm3/(N·m). Together, grain refinement, solid-solution strengthening and glaze lubrication raised the hardness to 265 HV5 at 2500 W (+49.7%) and lowered the room-temperature wear rate to 0.87 × 10−4 mm3/(N·m) (−18.7%). These results define a process window for repairing Inconel 718 with compositionally matched powder.
No takes yet. Share an insight, caveat, or question.
Chen et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: