Answers are grounded in this paper and cite their sources.
High-lithium dual-phase Mg–Li alloys exhibit excellent lightweighting potential, but their relatively low strength limits practical applications. In this study, water-cooled friction stir processing (FSP) of rolled LA103Z was examined by combining experiments with three-dimensional finite element analysis in Deform 3D. The simulations were used to investigate material-flow trajectories and the spatial and temporal distributions of temperature, stress, and strain under the investigated processing conditions. The tracked material points exhibited a truncated-conical flow region, while the predicted temperature and accumulated strain were generally higher on the advancing side than on the retreating side. Tool diameter and rotational speed had stronger effects on the predicted peak-temperature level than traverse speed, whereas traverse speed mainly influenced the heating and cooling rates and temperature uniformity. The local thermomechanical histories were subsequently introduced into a previously established CDRX–ISV model for LA103Z to calculate β-Li grain-size and regularized dislocation-density evolution. The predicted grain sizes were compared with experimental measurements; the calculated dislocation-density histories are presented as model outputs and were not independently verified by direct dislocation measurements. The main contribution is the spatially resolved analysis of material flow and thermomechanical histories and their sequential use in microstructure-evolution modeling, rather than the first demonstration of FSP-induced refinement or strengthening in LA103Z.
No takes yet. Share an insight, caveat, or question.
Zhai et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: