Answers are grounded in this paper and cite their sources.
Heat shrinkable film often pursues high thermal shrinkage of TD and low thermal shrinkage of MD. In this paper, PC is used as the modified material of PETG, and the two materials are mixed according to the ratio (PETG/PC) of 100/0, 95/5, 90/10, 80/20, 70/30, and the heat shrinkable film is prepared by blow molding. In addition, the thermal shrinkage, thermal, mechanical, and optical properties of the blended film are tested to explore the influence of PC content on PETG properties and determine the optimal formula. The addition of PC decreases the thermal shrinkage rate of the film. When the amount of PC is greater than or equal to 10%, the MD thermal shrinkage rate of the film is 0 when the film is below 130°C. When comparing the mechanical properties and optical properties of the blended films, it is found that the overall properties of the blended films with PC content of 10% are better. The blending ratio (PETG/PC) of 90/10 was determined as the optimal formula. PC brought a large number of benzene rings and side chain methyl functional groups into the blending system, destroyed the regularity of molecular chains, limited the movement ability of molecular chains, and made the molecular chain orientation incomplete, which was manifested as a decrease in thermal shrinkage rate. The SEM images show that PC exists in the PETG phase as a partially stretched nanosphere with TD, which proves that the orientation of TD is greater than that of MD. This is the reason why MD of blend film does not shrink at low temperatures, but TD shrinks. The PETG/PC blended film can improve the thermal shrinkage behavior of the existing PETG film.
No takes yet. Share an insight, caveat, or question.
Zhao et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: