Answers are grounded in this paper and cite their sources.
In this study, we propose to realize high-performance inertial Micro-Electro-Mechanical Systems (MEMS) mass sensors by the thick oxide as a mask layer fabrication technique. This method enables to reduce the air-gap to sub-μm in capacitively transduced MEMS with optical lithography and has been used to fabricate high aspect ratio sub-μm air-gap bulk mode MEMS mass sensors. MEMS devices have been designed and fabricated with the gap size as small as ~400 nm for ~38 μm thick SOI-based resonators (~95:1). Due to the conical characteristic of the gap, the mean air-gap has also been estimated as ~868 nm with 46 μm depth, which results in ~ 53:1 aspect ratio for the silicon test wafers that have been treated under the same conditions with the SOI-based devices. COMSOL simulation results and fabricated MEMS resonators coherently show that MEMS devices exhibit Lamé mode at 4.099 MHz resonance frequency with the estimated quality factor around 20,000, and extensional mode at 4.467 MHz with the estimated quality factors around 18,000 in the air. The motional resistance has been estimated as small as 27.28 Ω for the Lamé mode operating at 40 V. In this study, two different bulk modes have been considered as sensitive and uniform mass sensors for the detection of airborne particles. Then, minimum mass measurement capability of both modes has been experimentally estimated as 0.51 ng and 0.47 ng for Lamé and extensional modes, respectively. The latter, a proof-of-concept mass measurement has been conducted to deduce the resonance frequency shifts of both modes upon an added mass. This work demonstrates optimization of the thick oxide mask layer fabrication technique and realization of high aspect ratio bulk-mode MEMS mass sensors.
No takes yet. Share an insight, caveat, or question.
Soysal et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: