This is the authors' abstract. We don't add key points for this paper.
This paper presents a high jitter performance injection-locked clock multiplier (ILCM) using an ultra-low power (ULP) voltage-controlled oscillator (VCO) for IoT application in 65-nm CMOS. The proposed transformer-based VCO achieves low flicker noise corner and sub-100µW power consumption. Double cross-coupled NMOS transistors sharing the same current provide high transconductance. The network using high-Q factor transformer (TF) provides a large tank impedance to minimize the current requirement. Thanks to the low current bias with a small conduction angle in the ULP VCO design, the proposed TF-based VCO's flicker noise can be suppressed, and a good PN can be achieved in flicker region (1/f3) with sub-100µW power consumption. Thus, a high figure-of-merit (FoM) can be obtained at both 100kHz and 1MHz without additional inductor. The proposed VCO achieves phase noise of -94.5/-115.3dBc/Hz at 100kHz/1MHz frequency offset with a 97µW power consumption, which corresponds to a -193/-194dBc/Hz VCO FoM at 2.62GHz oscillation frequency. The measurement results show that the 1/f3 corner is below 60kHz over the tuning range from 2.57GHz to 3.40GHz. Thanks to the proposed low power VCO, the total ILCM achieves 78 fs RMS jitter while using a high reference clock. A 960 fs RMS jitter can be achieved with a 40MHz common reference and 107µW corresponding power.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Sun et al. (2021) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: