Answers are grounded in this paper and cite their sources.
This study investigated the effects of aluminum flue dust (AFD) and steel dust (SD) as partial cement-replacement materials on the fresh-state, mechanical, durability, and microstructural properties of cement pastes and mortars. To achieve this objective, binary and ternary mixtures were produced by incorporating 5–20 wt% of AFD and SD relative to cement in cement pastes and mortars. The results showed that AFD accelerated the setting time because of its high alumina content, whereas SD delayed hydration because of the iron oxide content in its composition. The incorporation of AFD and SD reduced drying shrinkage; at 400 days, the reductions relative to the control mortar (356 µε) were approximately 5.62% for AFD20, 11.52% for AFD10SD10, and 15.45% for SD20. However, increasing AFD and SD replacement also reduced compressive strength, flexural strength, and ultrasonic pulse velocity. Durability tests revealed enhanced resistance to chemical attack. After 180 days of exposure, SD20, AFD20, and AFD10SD10 exhibited approximately 2.8%, 16.7%, and 5.6% lower weight loss, respectively, in hydrochloric acid, and approximately 11.4%, 35.7%, and 24.3% lower weight loss, respectively, in sodium sulfate solution, compared with the control mortar. The improvement in chemical durability is attributed to the lower formation of calcium hydroxide, which is highly susceptible to leaching. These results indicate that AFD and SD may support waste recycling and the circular economy through partial cement replacement, reduced Portland cement demand, and diversion of industrial waste from disposal; however, environmental safety and life-cycle benefits require separate verification.
No takes yet. Share an insight, caveat, or question.
Iqbal et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: