Key result
Diastolic CT-FFR outperforms systolic CT-FFR for detecting functionally significant coronary stenosis with an AUC of ~0.91.
Why the study?
The reliability of the conventionally preferred diastolic phase for CT-FFR is challenged by high heart rates or myocardial bridging, and the optimal cardiac reconstruction phase based on patient-specific characteristics needed to be identified.
Does diastolic-phase reconstruction improve the diagnostic accuracy of CT-FFR compared with systolic-phase reconstruction across different anatomical (myocardial bridging) and physiological (heart rate) patient profiles in suspected coronary artery disease?
Cohort (n=138)
Independent CT-FFR analyses performed by two radiologists fully blinded to the invasive FFR results
No
Does diastolic-phase reconstruction improve the diagnostic accuracy of CT-FFR compared with systolic-phase reconstruction across different anatomical (myocardial bridging) and physiological (heart rate) patient profiles in suspected coronary artery disease?
Diastolic-phase reconstruction is essential for accurate CT-FFR assessment in the general population, borderline grey-zone lesions, and patients with myocardial bridging to prevent false-positive pseudo-ischemia, whereas systolic reconstruction is a viable alternative at heart rates >70 bpm on single-source CT.
Answers are grounded in this paper and cite their sources.
Diastolic CT-FFR may enhance accuracy over systolic; leaves open whether phase selection should be individualized by heart rate or anatomy.
Background Computed tomography-derived fractional flow reserve (CT-FFR) is a promising non-invasive tool, but the reliability of the conventionally preferred diastolic phase is challenged by high heart rates or myocardial bridging. This study aimed to compare the diagnostic performance of systolic versus diastolic CT-FFR to identify the optimal reconstruction phase based on patient-specific characteristics. Methods This retrospective study analyzed 155 vessel segments from 138 patients with suspected coronary artery disease undergoing coronary CT angiography and invasive FFR. CT-FFR was calculated in diastolic and systolic phases. Diagnostic accuracy was assessed against invasive FFR (≤ 0.80 as positive), with stratified analyses for the FFR grey zone (0.75–0.85), myocardial bridging, and heart rate (≤ 70 vs > 70 beats per minute). Results Among 138 patients (mean age 65.4 ± 9.8 years; 91 men), diastolic CT-FFR demonstrated superior overall performance (AUC 0.91 vs 0.87; P = 0.021). In the FFR grey zone, systolic CT-FFR showed lower specificity (52.8% vs 77.8%; P < 0.05). In myocardial bridging patients, systolic CT-FFR had significantly lower AUC (0.79 vs 0.90; P = 0.011). In patients with heart rates > 70 bpm, systolic CT-FFR showed numerically higher but non-significant performance (AUC 0.87 vs 0.85; P = 0.418). Conclusions The optimal cardiac phase for CT-FFR is patient-dependent. While diastole remains superior for the general population and critical for patients with myocardial bridging or borderline lesions, the systolic phase may provide a viable alternative for patients with high heart rates when imaged on single-source CT platforms. An individualized cardiac phase-selection strategy is recommended to optimize the diagnostic accuracy of CT-FFR.
No takes yet. Share an insight, caveat, or question.
Song et al. (2026) conducted a cohort in Suspected coronary artery disease (n=138). Diastolic-phase CT-derived fractional flow reserve (CT-FFR) reconstruction (70%-80% R-R interval) vs. Systolic-phase CT-FFR reconstruction (30%-40% R-R interval) was evaluated on Diagnostic performance (Area Under the ROC Curve [AUC]) against invasive FFR <= 0.80 on a per-vessel basis (n=155) (AUC 0.91 vs 0.87, 95% CI 0.86-0.96, p=0.021). Diastolic CT-FFR demonstrated superior overall diagnostic performance compared with systolic CT-FFR for detecting functionally significant coronary stenosis.
Synapse has enriched 10 related papers. Consider them for comparative context: