Answers are grounded in this paper and cite their sources.
Rotary ultrasonic-assisted milling (RUM) can improve the machining of difficult-to-cut materials, but its effect on machining performance varies with cutting conditions. Existing studies have mainly focused on average cutting responses and low frequency process dynamics. To further understand the dynamic response mechanism in RUM, this study investigated the characteristic frequency components of the tool system from a broadband dynamic perspective. Cutting force and acoustic measurements were used as complementary signals to characterize the machining dynamics, and finite-element modal analysis was employed to relate the measured spectral components to the structural modes of the transducer and tool unit. Characteristic narrowband components near 7.5 and 9 kHz were identified beyond the tooth passing frequency and its harmonics. The 7.5 kHz component was close to the simulated axial mode at 7.78 kHz but showed weak correspondence with surface roughness variation, whereas the 9 kHz component was close to the simulated lateral swinging mode at 9.31 kHz and showed a clearer relation to surface roughness. The results indicated that ultrasonic assistance selectively modified dynamic responses related to the mode rather than uniformly suppressing vibration.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: