Answers are grounded in this paper and cite their sources.
The main idea of this study is to create a 3D printed scaffold to improve the mechanical behavior of hydrogels for bone tissue engineering. This paper investigated the effects of infill percentage and strand diameter on the 3D printed polycaprolactone/Chitosan/HA scaffold's mechanical properties. The printing parameters were optimized by central composite design in response surface methodology. The X, Y, and Z axes measured stiffness (N/m), compressive strength (MPa), and elongation at break (%). The results showed that the highest stiffness of all samples (in both vertical (65 MPa) and horizontal (32 MPa) loading dimensions) could be found in the scaffolds with 40% infill and the strands with 400 μm diameter. It was also indicated that the degradability of the samples could be improved (0.33%–1.03%) with a reduction of strand diameter from 600 to 400 μm. The most swelling was attributed to the scaffold with 50% infill and strand diameter of 600 μm. Hydrophilicity was improved by employing chitosan (78.3°–66.3°). Results depicted good biocompatibility (>80%) of the samples. To sum up, the idea of a biscaffold with suitable engineering can be a good idea to enhance the mechanical behavior of hydrogel‐based scaffolds.
No takes yet. Share an insight, caveat, or question.
Salami et al. (2023) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: